How to Set Up Your Chainway CP30 RFID Printer
Welcome to our guide on setting up the Chainway CP30 RFID Printer. This article will walk you through the setup process, including connecting your printer, loading the ribbon and tags, and initial configuration. If you prefer a visual guide, feel free to watch the embedded video below.
Unpacking Your Bundle
Each RFIDLinked Printer Bundle includes:
- Thermal Transfer Ribbon
- ARC-compatible tags
- Power cable
- USB data transfer cable
- Pre-installed wireless module
Understanding the Printer Components
Front of the Printer:
- Power button
- Printer feed button
- 3.5-inch LCD touch display
- Two LED indicator lights
- Release buttons on each side for opening the clam-shell
Back of the Printer:
- External spool feed port
- USB A header
- USB B header
- RJ45 Ethernet network port
- Power jack/connector
Connecting the Printer
Power and USB Connections:
- Connect the power cable to the power jack.
- Connect the USB data cable to the USB B header.
Inside the Printer
Opening the Clam-shell:
- Press the release buttons on each side to open the clam-shell.
- Refer to the handy guides inside the printer for assistance.
Adjustable Tag Holder:
- Located inside at the back of the printer.
Ribbon Carrier:
- Located inside towards the front.
- Open by pushing the two yellow tabs.
Loading the Ribbon
Prepare the Ribbon Carrier:
- Open the ribbon carrier and remove the test label.
Insert the Ribbon Spool:
- Each spool holder has a keyed side and can only be inserted one way.
- Insert the holder's square portion from the left side of the ribbon.
- Ensure it feeds the empty roll from the bottom.
Load the Ribbon:
- Insert the empty roll from the top, matching the square side to the carrier.
- Insert the ribbon from the bottom of the carrier.
- Adjust the yellow wheels on the carrier to take out some slack.
Installing the Tags
Refer to the Diagram:
- Check the diagram at the bottom of the printer for correct tag orientation.
Adjust the Tag Holder:
- Release the tag holder by pulling up on the yellow tab.
- Insert the spool of ARC-approved tags.
- Secure the tags by pressing down on the yellow tab.
Feed the Tags:
- Adjust the guides under the ribbon carrier to fit your tag size.
- Ensure the tags feed through without snagging.
- Close the Carrier and Clam-shell.
Powering On and Initial Setup
Turn On the Printer:
- Hold down the power button for at least 3 seconds.
Display Overview:
- Top left: Firmware version.
- Top right: Connectivity status.
- Bottom left: Printer settings, testing, configuration info, and smart printing options.
Printer Setup:
- Select Settings > Printer Setup
- Ensure the printer method is set to “TT” (Thermal Transfer). If set to Direct Thermal, switch to “TT”.
- Confirm the default rotation is set to 180. Save the settings.
RFID Setup:
- Select Settings > RFID Setup > Calibration
- This will calibrate the printer with the chip on your RFID tags ensuring it is able to properly communicate with them.
NOTE: It is recommended that you re-run the RFID Calibration anytime you change a roll of tags.
Label Setup:
- Select Settings -> Label Setup
- Ensure that the label type is set to "GAP LABEL"
- Run the Label Calibration.
NOTE: It is recommended that you re-run the Label Calibration anytime you change a roll of tags.
The Chainway CP30 RFID printer is a
user-friendly, cost-effective, and reliable solution for printing RFID
labels.
For purchasing or more information, visit RFIDLinked.com. If you have any questions, feel free to contact us!